![]() You can create relations between promoted parameters and other dimensions in the model with the Parameters Pane. Your parameters show up in the Groups tab.įor more advanced driving dimensions you need to have a dimension on an annotation plane:ĭesignModeler has the familiar checkbox to “promote” parameters out to Workbench: SpaceClaim let’s you create a parameter from almost any operation: Table of Contents (for quick jumping around): This document is intended to be a quick reference of how to do so, letting you get over this initial hurdle to take full advantage of the promise of Digital Exploration. While ANSYS Workbench and DesignXplorer manage your parameters in a consistent interface, setting up a parameter is different in each of the software tools and not always obvious. ![]() Sophisticated parametric exploration, optimization and robustness is now at your fingertips. With ANSYS R18’s promise of digital exploration, DesignXplorer is now included with all CFD, Mechanical and Multiphysics bundles. ![]() With very little marginal work a completed model can be parameterized to simulate scenarios limited only by your computational time and resources (have you considered a Parametric Pack for parallel design solves?). One of the best ways to get value out of your simulation is to do parametric analysis.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |